1. Turn off TVs with remote. 

Open electrical panel LP-BA. turn off circuit breaker 31 (bottom left side) wait 30 seconds and turn the breaker back on. Close the panel door.

The system was installed by Cinema Sounds (Tom Nagel) and Mat Lawson did the installation work.

Jim Murphy serviced the TV system on 6/4 & 5/2025 bedause the 2 TVs were not working together.

The 2 HDMI cables attached to the cart in the closet are for the wall mounted TVs and the projector.

There are three DV switches that are physically located in the rear of the left TV. It is hard to see and work behind the TVs. Care must be exercised to prevent the unplugging of necessary wired connections. If one of the TVs or Chrome Cast or Apple TV does not work, verify that all the power supplies are securely plugged in. The transformer power supplies can come unplugged with time.

The only thing behind the right TV are the two HDMI cables and a CAT 5 cable. These must be kept plugged into the proper inputs or the TVs will not sync properly.

The cables should be labeled as to the correct input jacks for future reference. The circuit breaker should be labeled as well.